# SK-AM62P-LP

You don't need to use any MIB for this device-type. In our setup, we are making use of a [No-MIB](/hardware/mibs/no-mib.md).


![SK-AM62P-LP connectivity](/_images/sk-am62p-lp/sk-am62p-lp-top.jpg){align=center}

## Components

The following components are required to fully automate the board:

- [No-MIB](/hardware/mibs/no-mib.md)
- Short RJ45 network cable
- USB-A male to MicroUSB male cable x2
- USB-C male to USB-C male cable
- USB-A male to USB-C male cable
- Micro SD Card

## Connectivity

### Automation Interface

Connect a micro-USB cable from LAA Port 3 (facing upward) to the SK-AM62P-LP
USB `JTAG`\\`XDS` port.

### USB

Connect the `LAA USB OTG` port (front facing) to the SK-AM62P-LP `USB-A` port.

### Network

Connect the first ethernet port to the LAA private network interface.

### Power

Connect a USB C-to-C cable from LAA Port 1 (facing upward) to the SK-AM62P-LP
USB `POWER` port.

### Serial

Connect a USB cable from LAA Port 2 (facing upward) to the SK-AM62P-LP USB `UART`\\`Serial` port.